CuBig II
High capacity - small footprint.
For larger supermarkets and industries
High energy efficiency, high capacity and high quality
A TRUE CLIMATE SOLUTION
CuBig II can combine cooling, freezing, air-con and heating in one.
It provides up to 570 kw cooling and 850 kW heating capacity and still only has a width of 0,8 m.
The CuBig II is also ideal as heat Pump for commercial and industrial buildings.
It can be used in a wide range of applications, but is especially suitable for applications like large supermarkets to cold room storage or even distribution centers.
Compact design
Placement of rack outside or inside
-
- Optional enclosure available
- Freeing up expensive square meters
-
- Flexible placement of compressors - free seating
- Modular design to ensure minimum length
Narrow design
-
- Goes through normal doors - Width only 800 mm
- All options within the frame
Easy handling
-
- Handling with forklift
- Fully welded frame – one piece
- Protected pipes
High capacity
Capacity up to 570 kW cooling and 850 KW Heating-
- Better and more advanced oil handling
- Enable biggest available compressors
- Copper/k65 piping
Optimised capacity regulation with less compressors
-
- Maxed out capacity without compromising part load requirements
Compact design with max 976 l receiver capacity
-
- 450 l in one single receiver
- 450 l in one single receiver
Short lead time
Fully factory tested
INCREASED ENERGY EFFICIENCY
-
- Optimised pipe design with lowest possible pressure drop
- Advanced heat recovery
- Ultra-low Superheat with or without ejector technology
- Hot gas defrost
- Liquid Power Cooler
- COP Hunter
- Permanent Magnet Motors on all compressors
HIGH QUALITY
Copper Piping
-
- Easy service
- Hydrogen soldering instead of welding
Optimised design
-
- Less connections
- Less threads
Fully welded frame with improved strength and vibration handling
-
- New compressor plate
- Fully new mechanical design
Outdoor installation
No indoor space? No problem! Whether you do not have enough space or want more indoor space for production or selling, our enclosures are the ideal solution. The rack will be delivered in the enclosure, easy to install in a parking lot, at a roof top, or any other outdoor place.
Learn more about our enclosures
- Standard equipment
- Patented internal heat exchanger in receiver
- Hot gas dump
- Liquid line injection
- Filter drier
- CO2 low-level switch
- Frequency inverter on MT1 and IT1
- Controllers available
- Danfoss
- Carel
- Wurm
- Eckelmann
- Standard design pressures
- High pressure: 130 bar
- Receiver pressure: 80 bar
- MT suction pressure: 52 bar
- LT suction pressure: 30 bar
- Design pressure: 80/60 bar
- Options available
- Climate solution
- Heat recovery
- Advansor patented air conditioning
- Chiller module
- Heat pump evaporator function
- Energy efficiency
- Permanent magnet motor technology
- Liquid Power Cooler
- Hot gas defrost
- Ejector technology
- Active liquid subcooling
- Cylinder unloading technology
- Ultra-Low Superheat
- Parallel compression
- Multiple suction groups
- Advansor COP Hunter
- Safety
- Double high-pressure and gas bypass valves
- Double pressure relief valves on changeover valve
- Emergency cooling unit
- CE-marked PRV manifold
- Suction accumulators
- Backup controllers
- Oil separator bypass
- Emergency bypass of 1st heat recovery
- Emergency bypass of 2nd heat recovery
- Monitoring
- Energy meter
- CO2 liquid level measurement
- Easy installation
- Designed in two
- Project delivered in modules
- Enclosure for outdoor installation