Easy power-Up and commissioning
Powering up an Advansor rack is fast and easy. When your rack is delivered on-site it is already:
-
Tested from factory including full I/O test
-
Controllers programmed to site specific conditions
However, we want you to get the best experience with our products.
With commissioning support from our aftersales team, you are ensured the highest energy efficiency and high-quality training so you can save time on future installations.
COMMISSIONING PACKAGE
To optimize your resources the start-up package has 2 steps.
2-3 weeks before the start-up we suggest a pre-commissioning support meeting, where we meet online. This ensures that we are all well-prepared for the on-site commissioning support. We will review:
- Quick Start Guide
- Introduction to the rack and documentation
- Alignment of expectations to the commissioning support
- Questions
Commissioning support including training onsite
We support you, so your rack is perfectly adjusted to the climate and the surroundings:
- Adjustment and optimization of the rack and installation for most efficient operation
- Optimization of controllers and use of the different controller systems
- Training in your new rack:
- Starting up the rack and how to operate the system
- How the different components work
- Safety equipment, PID and how CO2 works
- Service and maintenance of the rack
UP TO 18% ENERGY SAVINGS WHEN ADJUSTING YOUR CO2 RACK TO THE CLIMATE AND SURROUNDINGS
Prices
MiniBooster, ValuePack, CuBig, CuBig II - all including IT, Chiller Module
1 day commissioning support and training on-site: EUR 2,100
SteelX, SteelXL, racks with 3 suction groups, ULS Module, ValuePack Low Superheat, Pump Module and non-standard
2 -day commissioning support and training on-site: EUR 4,000
If required extra days will be charged at EUR 2,100 per day. This might apply to customized solutions, special conditions and requirements.
Prices are valid in Europe and include hotel, food and mileage. Outside Europe pricing is based on invoicing.
Place
On-line pre-commissioning support meeting and on-site commissioning support with training
Booking
Commissioning support must be booked minimum 4 weeks in advance.
Please fill in the form below to request commissioning support. Please note that your commissioning support is not confirmed until you get a confirmation from our Aftersales Team.
Please note that Advansor is not responsible for commissioning. The customer holds full responsibility for the commissioning process. The Advansor Aftersales Engineer will be on-site to support, train, and guide the customer during commissioning. The Advansor Aftersales Engineer will not bring any tools or perform any mechanical or electrical work on the rack.